Active Test: Operation

NOTE: For the active test of the body control, activate the actuator using Subaru Select Monitor without operating switches in order to inspect the body integrated unit and actuator.

On [Start] display, select [Diagnosis].
On [Vehicle selection] display, input the target vehicle information and select [OK].
On [Main Menu] display, select [Each System].
On [Select System] display, select [Body Control], and then select [Enter].
On [Select Function] display, select [Active Test].

NOTE:

If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
The operation is disabled for the models with keyless access with push button start system because the key lock solenoid is not installed.
For detailed operation procedures, refer to "Application help".