LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Entertainment System >> Antenna >> Removal >> Telematics Sub Antenna

Telematics Sub Antenna

CAUTION: Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the audio assembly or navigation assembly. Ref. to ENTERTAINMENT>Audio>REMOVAL .
  3. Remove the combination meter assembly. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter>REMOVAL .
  4. Remove the GPS antenna. Ref. to ENTERTAINMENT>GPS Antenna>REMOVAL .
    NOTE: Remove the antenna only. Do not pull the cord.
  5. Remove the telematics sub antenna.
    1. Tie a string to the telematics sub antenna connector on the data communication module side.
      NOTE: A string makes operation easier during installation.
    2. Remove the screw and harness clamp, and pull out the telematics sub antenna cord from the combination meter side.
      Fig 1: Locating Screw And Harness Clamp Combination Meter Side
      G10408359Courtesy of SUBARU OF AMERICA, INC.
    3. After the telematics sub antenna has been pulled out, remove the string attached to the connector in step (1).