Combination Meter: Removal

Disconnect the ground cable from battery. Ref. to BATTERY , NOTE, Note.
Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.
Release the screws, clips and claws, and remove the visor - combination meter.

Fig 1: Locating Combination Meter Visor Screws, Clips And Claws
Courtesy of SUBARU OF AMERICA, INC.
Remove the combination meter assembly.
CAUTION:
- Be careful not to damage the meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.
1. Remove the screws.
  
  Fig 2: Locating Combination Meter Assembly Screws
  Courtesy of SUBARU OF AMERICA, INC.
2. Pull the combination meter assembly toward you and disconnect the connector.
Fig 3: Pulling Combination Meter Assembly
Courtesy of SUBARU OF AMERICA, INC.