Expansion Valve: Removal

Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
Using the refrigerant recovery system, discharge refrigerant. < Ref. to PROCEDURE , Refrigerant Recovery Procedure. >
Remove the intercooler.
- Except for STI model: < Ref. to REMOVAL , Intercooler. >
- STI model: < Ref. to REMOVAL , Intercooler. >
Detach the clips and bolts, and detach the hose - pressure suction and the pipe - evaporator cooling.
CAUTION: Seal the disconnected hose, pipe and engaging part of expansion valve with a plug or vinyl tape to prevent foreign matter from entering.

Fig 1: Locating Clips And Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt, and remove the expansion valve - cooling.
CAUTION: Seal the pipe and engaging part of expansion valve with a plug or vinyl tape to prevent foreign matter from entering.

Preparation tool:

Hexagon wrench: 4 mm (0.16 in)

Fig 2: Removing Expansion Valve - Cooling
Courtesy of SUBARU OF AMERICA, INC.