DTC P0018 Crankshaft Position - Camshaft Position Correlation Bank 2 Sensor A: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.

Engine stalls.
Improper idling

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode < Ref. to OPERATION , Clear Memory Mode. >, and Inspection Mode < Ref. to PROCEDURE , Inspection Mode. >.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK CURRENT DATA. Start the engine and let it idle. Read the values of «WT Adv. Ang. Amount L» and «OCV Duty L» using the Subaru Select Monitor. NOTE: For detailed operation procedures, refer to "Current Data Display For Engine". < Ref. to SUBARU SELECT MONITOR . >	Is the value of «WT Adv. Ang. Amount L» approx. 0 deg, and the value of «OCV Duty L» approx. 10%?	Perform the following procedures, and clean the oil routing. Replace the engine oil and idle the engine for 5 minutes, and then replace the oil filter and engine oil. < Ref. to REPLACEMENT , Engine Oil. > < Ref. to ENGINE OIL FILTER . >	Check the following item and repair or replace if necessary. Oil pipe (clog) Oil flow control solenoid valve (clog or dirt of oil routing, setting of spring) Intake camshaft (dirt, damage of camshaft) Timing belt (matching of timing mark)