LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Cooling System (WRX-STI)) >> Radiator Main Fan and Fan Motor >> Removal

Radiator Main Fan and Fan Motor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. < Ref. to REMOVAL , Front Under Cover. >
  4. Disconnect the connector from the main fan motor.
    Fig 1: Locating Main Fan Motor Connector
    G08539520Courtesy of SUBARU OF AMERICA, INC.
  5. Lower the vehicle.
  6. Remove the air intake duct. < Ref. to REMOVAL , Air Intake Duct. >
  7. Remove the reservoir tank. < Ref. to REMOVAL , Reservoir Tank. >
  8. Remove the bolts which secure the radiator main fan motor assembly and the over flow pipe.
    Fig 2: Locating Radiator Main Fan Motor Assembly Bolts
    G06345372Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the radiator main fan motor assembly from the upper side of the vehicle.