CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.

Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B).
Tightening torque:

Bolt (A)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 1: Identifying Transmission Cushion Rubber To Center Crossmember And Nut
Courtesy of SUBARU OF AMERICA, INC.
Install the front crossmember and rear crossmember.
Tighten the transmission cushion rubber mounting nut.
Tightening torque:

T1: 35 N.m (3.6 kgf-m, 25.8 ft-lb)

T2: 70 N.m (7.1 kgf-m, 51.6 ft-lb)

T3: 140 N.m (14.3 kgf-m, 103 ft-lb)

Fig 2: Identifying Transmission Cushion Rubber Mounting Nut With Torque Specification
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the heat shield cover.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the rear exhaust pipe and muffler. < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
Install the center exhaust pipe. < Ref. to INSTALLATION , Center Exhaust Pipe. >