Transfer Drive Gear: Inspection
WARNING: This page is about a different variant/trim than selected.
- Ball bearing
Replace the bearings in the following cases.
- Damage or rust on the bearings
- Wear, or damage
- The bearing does not rotate smoothly or an abnormal noise is emitted.
- Transfer drive gear
Replace the drive gear in following case:
- If the drive gear tooth surface and shaft are excessively damaged or broken.
- Measure the clearance between the snap ring and ball bearing inner race with a thickness gauge.
Standard clearance between the snap ring and inner race:
0 - 0.15 mm (0 - 0.0059 in)
- If the measurement is out of specifications, reselect an appropriate snap ring.
Snap ring Part No. Thickness mm (in) 805045050 1.76 (0.069) 805045060 1.88 (0.074) 805045070 2.00 (0.079) After replacing the snap ring, reinspect the clearance.