Reverse Check System: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the manual transmission assembly from the vehicle. < Ref. to REMOVAL , Manual Transmission Assembly. >
Prepare the transmission for overhaul. < Ref. to PREPARATION FOR OVERHAUL . >
Remove the extension case. < Ref. to REMOVAL , Extension Cases. >
Remove the snap ring and washer.

Fig 1: Removing Snap Ring And Washer
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check shaft and return spring.

Fig 2: Removing Reverse Check Shaft And Return Spring
Courtesy of SUBARU OF AMERICA, INC.
Remove the straight pin, and remove the reverse check lever and oil seal.

Fig 3: Removing Reverse Check Lever And Oil Seal
Courtesy of SUBARU OF AMERICA, INC.
Remove the plug, then remove the gasket, reverse check spring and reverse check plunger.

Fig 4: Removing Gasket, Reverse Check Spring And Reverse Check Plunger
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse lock plunger.

Fig 5: Identifying Reverse Lock Plunger
Courtesy of SUBARU OF AMERICA, INC.