Differential Side Retainer

WARNING: This page is about a different variant/trim than selected.

Remove the O-rings.

Fig 1: Identifying O-Rings
Courtesy of SUBARU OF AMERICA, INC.
Remove the oil seal

Fig 2: Removing Oil Seal
Courtesy of SUBARU OF AMERICA, INC.
Remove the claw of ST1, and attach the claw of ST2.
ST1 398527700 PULLER ASSY

ST2 18760AA000 CLAW

Fig 3: Removing Claw Of ST1
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the taper roller bearing outer race.
ST1 398527700 PULLER ASSY

ST2 18760AA000 CLAW

Fig 4: Removing Taper Roller Bearing Outer Race
Courtesy of SUBARU OF AMERICA, INC.