Section 2 (Engine Intake System (Induction) And Turbocharger (WRX-STI)): Intercooler: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the intake duct to the intercooler duct.
Tightening torque:

3 N.m (0.3 kgf-m, 2.2 ft-lb)

Fig 1: Locating Intake Duct
Courtesy of SUBARU OF AMERICA, INC.
Install the clip (A) and intercooler duct to the intercooler.
NOTE: Use a new gasket.

Tightening torque:

16 N.m (1.6 kgf-m, 11.8 ft-lb)

Fig 2: Locating Intercooler Duct Clip
Courtesy of SUBARU OF AMERICA, INC.