Execution Condition
WARNING: This page is about a different variant/trim than selected.
VALUE SPECIFICATION - MONITOR A1 PRIMARY OXYGEN SENSOR FLUCTUATION
| Secondary Parameters | Execution condition |
|---|---|
| Battery voltage | ≥ 10.9 V |
| Barometric pressure | ≥ 75.1 kPa (563 mmHg, 22.2 inHg) |
| Closed loop control with primary oxygen sensor | Closed |
| Engine speed | > 1600 rpm |
| and | |
| < 3200 rpm | |
| Intake air mass per crankshaft revolution | > 0.80 g/rev (0.03 oz/rev) |
SPPED SPECIFICATION - MONITOR B1 CRANKSHAFT SPEED FLUCTUATION
| Secondary Parameters | Execution condition |
|---|---|
| Misfire diagnosis monitor | Active |
| Accelerator pedal position | 0% |
| Vehicle speed | ≤ 482.78 km/h (300 MPH) |
| Engine speed | > 1800 rpm |
| and | |
| < 2800 rpm | |
| Intake air mass per crankshaft revolution | > 0.8 g/rev (0.03 oz/rev) |
| and | |
| < 1.5 g/rev (0.05 oz/rev) | |
| Fuel system status (Primary Oxygen sensor) | = Closed loop |