PCV Hose Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Install the PCV hose assembly C onto the cylinder block RH.
NOTE: Use a new clamp for the PCV hose assembly C, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Identifying Clamp Pliers (ST18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating PCV Hose Assembly Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the turbocharger. < Ref. to INSTALLATION , Turbocharger. >
Install the intake manifold. < Ref. to INSTALLATION , Intake Manifold. >
Install the PCV hose assembly B onto the intake duct.
NOTE: Use a new clamp for the PCV hose assembly B, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 3: Identifying Clamp Pliers (ST18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Locating PCV Hose Assembly Clamp
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector to the PCV hose assembly B.

Fig 5: Locating PCV Hose Assembly Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the PCV hose assembly A to the PCV pipe, and install the PCV hose assembly A to the clip (B).
NOTE: Use a new clamp for the PCV hose assembly A, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 6: Identifying Clamp Pliers (ST18353AA000)
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector (A) to the PCV hose assembly A.

Fig 7: Locating PCV Hose Assembly Connector
Courtesy of SUBARU OF AMERICA, INC.