LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (M/T Clutch System) >> Clutch Pipe and Hose >> Removal

Clutch Pipe and Hose: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the collector cover. (Except for STI model) < Ref. to REMOVAL , Collector Cover. >
  3. Remove the intercooler. < Ref. to REMOVAL , Intercooler. > < Ref. to REMOVAL , Intercooler. >
  4. Drain the brake fluid. < Ref. to CLUTCH FLUID . >
  5. Remove the clutch pipe from the master cylinder.
  6. Disconnect the hose from operating cylinder.
  7. Remove the clutch hose bracket from the bulkhead.
  8. Remove the clutch pipe from the clutch hose.
  9. Remove the clutch pipe and clamp from the clutch hose bracket.
scientia non olet · About LEMON Manuals