Front Wheel Bearing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Inspect the condition of front wheel bearing grease.
- Jack-up the front side of vehicle.
- While holding the front wheel by hand, swing it in and out to check bearing free play.
- Loosen the wheel nuts, and remove the front wheel.
- If the bearing free play exists in step 2) above, attach a dial gauge to the hub and measure axial play in axial direction.
Service limit:
Straight-ahead position within 0.05 mm (0.0020 in)
- Remove the bolts and self-locking nuts, and extract the front arm from front crossmember.
- Remove the joint of front drive shaft from transmission. < Ref. to FRONT AXLE . >
- While supporting the front drive shaft horizontally with one hand, turn the hub with the other hand to check for noise or binding.
If the hub is noisy or binds, replace the front axle.