LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (General Information) >> Pre-delivery Inspection >> Pre-Delivery Inspection (PDI) Procedure >> Towing Hook (Eyebolt)

Towing Hook (Eyebolt)

WARNING: This page is about a different variant/trim than selected.
NOTE: At factory shipment, the towing hook (eyebolt) is installed to the rear bumper for securing the vehicle during transportation. Follow the procedure below to store the towing hook (eyebolt) to the holder in the spare tire.
  1. Remove the towing hook (eyebolt) from the rear bumper.
    Fig 1: Identifying Rear Bumper Towing Hook (Eyebolt)
    G10289647Courtesy of SUBARU OF AMERICA, INC.
  2. Store the towing hook (eyebolt) to the holder in the spare tire.
    Fig 2: Identifying Towing Hook (Eyebolt)
    G10289648Courtesy of SUBARU OF AMERICA, INC.
  3. Install the supplied rear hook cover to rear bumper.
    Fig 3: Identifying Rear Bumper Hook Cover
    G10264629Courtesy of SUBARU OF AMERICA, INC.