LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (General Information) >> Pre-delivery Inspection >> Pre-Delivery Inspection (PDI) Procedure >> Seat Belt

Seat Belt

WARNING: This page is about a different variant/trim than selected.
  1. Check installation condition of seat belt.
  2. Pull out the seat belt and then release it. Check that the belt retracts smoothly.
  3. Check seat belt warning function.
    1. Turn the ignition switch to ON with the driver's and passenger's seat belt detached.
    2. Check the driver's and passenger's seat belt warning light blink for approx. 6 seconds and the buzzer sounds intermittently.
    3. Then, check the seat belt warning light illuminates and blinks repeatedly at a cycle of approx. 15 seconds. (If no passenger is on the passenger's seat, the seat belt warning light on passenger's seat does not operate.)
scientia non olet · About LEMON Manuals