Blind Spot Detection/Rear Cross Traffic Alert (BSD/RCTA)
WARNING: This page is about a different variant/trim than selected.
- Check that the BSD/RCTA system is activated and deactivated correctly.
- Press the BSD/RCTA OFF switch to check that "BSD/RCTA OFF" is displayed in the combination meter.
- Press the BSD/RCTA OFF switch again to check that the indicators of the right and left side door mirrors illuminate → go off and "BSD/RCTA OFF" is displayed in the combination meter.
- Check that the BSD/RCTA error message is not displayed.
- Check the rear bumper around the radar sensor for dirt, scratch, affixed stickers and poor paint coating.
- If any dirt is found, clean it off so that the rear bumper is not damaged.
- If any stickers are affixed, remove it so that the rear bumper is not damaged.
- If the bumper is damaged or has poor paint coating, refer to "CAUTION" in "Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS)". < Ref. to CAUTION , General Description. >