Steering Lock CM: Removal

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
Do not allow harness and connectors to interfere or get tangled up with other parts.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >

Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
Remove the column assembly - steering. < Ref. to REMOVAL , Steering Column. >
Remove the steering lock CM.
1. Secure the column assembly - steering in a vise.
2. Use the reverse tap or drill to remove the set bolt and remove the steering lock CM.
  CAUTION: Do not apply any impact to the set bolt by a chisel or punch. Doing so may damage the CM.
  
  Fig 1: Locating Steering Lock CM Set Bolt
  Courtesy of SUBARU OF AMERICA, INC.