DTC B1501 Power Supply System Error Detection: Wiring Diagram

Combination meter system Ref. to the appropriate SYSTEM WIRING diagram article.

Fig 1: Combination Meter System Wiring Diagram

G10270914

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK POWER SUPPLY CIRCUIT. Turn the ignition switch to ON, and confirm that the illumination of combination meter lights.	Does the illumination light?	Go to step 2.	Go to step 3.
2 CHECK DTC. Read the DTC of the meter using the Subaru Select Monitor. < Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) . >	Is DTC B1501 a current malfunction?	Go to step 3.	Go to step 5.
3 CHECK FUSE. Turn the ignition switch to OFF. Check the fuse. < Ref. to RELAY AND FUSE . >	Is the fuse OK?	Go to step 4.	Replace the defective fuse.
4 CHECK HARNESS. Disconnect the meter connector. Turn the ignition switch to ON. Using the tester, measure the voltage between terminals. Connector & terminal (i10) No. 20 (+) - Chassis ground (-): (i10) No. 40 (+) - Chassis ground (-):	Is the voltage 8.5 - 16.5 V?	Go to step 5.	Repair the open circuit of harness or replace harness.
5 CHECK CONNECTOR. Turn the ignition switch to OFF. Disconnect connectors.	Is there poor contact of connector?	Repair or replace the poor contact of connector.	A temporary change of voltage occurred.