Driver's Airbag Module: Removal

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag system components. < Ref. to CAUTION , General Description. >

Position the front wheels straight ahead.
Turn the ignition switch to OFF.
Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Repair Contents. >
Remove the driver's airbag module.
1. Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).
  
  Fig 1: Removing Driver'S Airbag Module Using Hexagon Wrench
  Courtesy of SUBARU OF AMERICA, INC.
2. Disconnect the horn harness and airbag connector, and remove the driver's airbag module. < Ref. to DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE AND PRETENSIONER , PROCEDURE, Airbag Connector. >
  
  Fig 2: Disconnecting Horn Harness And Airbag Connector
  Courtesy of SUBARU OF AMERICA, INC.