DTC P1C00: Battery "2" Monitor Module Performance: Trouble Symptom
WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
- EV traveling/Auto Start Stop does not operate.
- System operation check mode is prohibited. < Ref. to FAIL-SAFE CHART .>
- Charge warning light illuminates.
CAUTION:
Before performing diagnosis, refer to "CAUTION" in "General Description". < Ref. to
CAUTION , General Description.>
DTC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. Read the DTC. < Ref. to HYBRID POWERTRAIN CONTROL SYSTEM , OPERATION, Read Diagnostic Trouble Code (DTC).> |
Is DTC P1C00 detected? (current malfunction) | Replace the 12V engine restart battery sensor. < Ref. to BATTERY SENSOR .> | Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
|