LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Crosstrek Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Starting System & Charging System (Hybrid)) >> Integrated Starter Generator (ISG) >> Inspection >> Check Charge Warning Light

Check Charge Warning Light

WARNING: This page is about a different variant/trim than selected.

Inspect as follows, if the charge warning light illuminates.

DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK DTC.  Is DTC of HEV and IDI displayed? < Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) . > < Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) . > Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > Go to step 2. 
2 CHECK ISG SENSOR. 
  1. Turn the ignition switch to OFF and wait for 20 minutes.
  2. Start the engine.
  3. Check the warning light in the combination meter.
 Does the warning light illuminate? Go to step 3.  Temporary overheat occurs in ISG. Currently returned to normal.
3 CHECK COMBINATION METER. 
  1. Check the combination meter. < Ref. to OPERATION , System Operation Check Mode. >
 Is combination meter OK? Replace ISG. < Ref. to REMOVAL , Integrated Starter Generator (ISG). > Repair or replace the combination meter. < Ref. to INSPECTION , Combination Meter System. >
scientia non olet · About LEMON Manuals