Instrumentation System & Driver Information Center: General Description: Caution

Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting the battery ground cable. Otherwise, the memory is cleared.
Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.
Use gloves to avoid damage and getting fingerprints on the glass surface and meter surfaces.
Do not apply an excessive force on the printed circuit.
Do not drop or otherwise apply impact.
Connect the connectors securely during reassembly.
After reassembly, make sure that each component operates normally.
When the combination meter assembly has been replaced, be sure to perform the following operations.
- For models without the keyless access with push button start except for C5, be sure to perform the registration of immobilizer. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
- Be sure to reset the ODO fuel economy value of the multi-function display (MFD). (High grade type) < Ref. to ODO FUEL ECONOMY VALUE RESET (HIGH GRADE TYPE ONLY) , OPERATION, Multi-function Display (MFD) System. >
Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions of "AIRBAG SYSTEM" in this case. < Ref. to CAUTION , General Description. >
Be careful not to damage the airbag system wiring harness when servicing electrical parts and switches.
When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform the VDC setting mode. < Ref. to ADJUSTMENT , VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >