Combination Meter: Removal

Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note. >
NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.
Release the screws, clips and claws, and remove the visor - combination meter.

Fig 1: Locating Visor Clips And Claws - Combination Meter
Remove the combination meter assembly.
CAUTION:
- Be careful not to damage the meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.
1. Remove the screws.
  
  Fig 2: Locating Combination Meter Screws And Clips
2. Pull the combination meter assembly toward you and disconnect the connector.
  
  Fig 3: Pulling Combination Meter Assembly