LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> BRZ Premium >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Stabilizer Bar >> Removal

Front Stabilizer Bar: Removal

  1. Removal of front tire
  2. Removal of undercover front AL (Refer to REMOVAL )
  3. Removal of undercover COMPL T/M (Refer to REMOVAL )
  4. Removal of undercover front side rear LH
    1. Remove the three clips and remove the undercover front side rear.
      Fig 1: Locating Undercover Front Side Rear Clips
      G10215328Courtesy of SUBARU OF AMERICA, INC.
  5. Removal of undercover front side rear RH
    NOTE: Remove the part in the same manner as LH side.
  6. Removal of front stabilizer link assembly LH
    1. Secure the stud bolt and remove the nut.
    2. Remove the front stabilizer link assembly LH from the front shock absorber w/ coil spring.
      Fig 2: Removing Front Stabilizer Link Assembly LH From Shock Absorber
      G10215329Courtesy of SUBARU OF AMERICA, INC.
    3. Secure the stud bolt and remove the nut.
    4. Remove the front stabilizer link assembly LH from the stabilizer bar FR.
      Fig 3: Removing Front Stabilizer Link Assembly LH From Stabilizer Bar
      G10215330Courtesy of SUBARU OF AMERICA, INC.
  7. Removal of front stabilizer link assembly RH
    NOTE: Service the RH side in the same procedure as the LH side.
  8. Removal of sub frame COMPL LH
    1. Remove the four bolts, and remove the sub frame COMPL LH with the stabilizer bar FR.
      Fig 4: Removing Sub Frame COMPL LH
      G10215331Courtesy of SUBARU OF AMERICA, INC.
  9. Removal of sub frame COMPL RH
    NOTE: Service the RH side in the same procedure as the LH side.
  10. Removal of front stabilizer bracket No. 2 LH
    1. Remove the bolt and nut, and remove the front stabilizer bracket No. 2 LH.
      Fig 5: Locating Front Stabilizer Bracket No. 2 Bolt And Nut (LH)
      G10215332Courtesy of SUBARU OF AMERICA, INC.
  11. Removal of front stabilizer bracket No. 2 RH
    NOTE: Service the RH side in the same procedure as the LH side.
  12. Removal of stabilizer bar FR
    1. Remove the stabilizer bar FR.
  13. Removal of front stabilizer bar bushing No. 1 (installed on LH side)
    1. Remove the front stabilizer bar bushing No. 1 (installed on LH side) from the stabilizer bar FR.
  14. Removal of front stabilizer bar bushing No. 1 (installed on RH side)
    NOTE: Service the RH side in the same procedure as the LH side.
scientia non olet · About LEMON Manuals