TRANSMISSION VALVE BODY Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Installation of transmission valve body Assembly
1. Insert the spring and the check ball body into the transmission case.
2. Make sure that the accumulator piston, spring, and check ball body are installed to the transmission case.
  
  Fig 1: Installing Transmission Valve Body Assembly
  Courtesy of SUBARU OF AMERICA, INC.
  
  NOTE: If the accumulator piston, spring, and check ball body come off, apply auto fluid WS and install them.
3. Connect the lever pin to the manual valve hole.
  
  Fig 2: Connecting Lever Pin To Manual Valve Hole
  Courtesy of SUBARU OF AMERICA, INC.
4. Install the transmission valve body Assembly with 19 bolts.
  Standard value: T=11N.m {112kgf.cm} {8.1ft.lbf}
  NOTE:
  Bolt under head length:
  - 25 mm {0.984 in} (Bolt A)
  - 36 mm {1.417 in} (Bolt B)
  - 45 mm {1.772 in} (Bolt C)
  - 50 mm {1.969 in} (Bolt D)
  Fig 3: Installing Transmission Valve Body Assembly With Bolts
  Courtesy of SUBARU OF AMERICA, INC.
5. Install the detent spring and detent spring cover with a bolt.
  Standard value: T=10N.m {102kgf.cm} {7.4ft.lbf}
Transmission wire connection (refer to INSTALLATION )
Installation of valve body oil strainer Assembly (refer to INSTALLATION )
Installation of transmission oil pan Sub-Assembly (ATM) (refer to INSTALLATION )
Installation of exhaust pipe Sub-Assembly FR (refer to INSTALLATION )
Connection of battery ground terminal (refer to INSTALLATION )
Fill of automatic transmission fluid (refer to ADJUSTMENT )