TRANSMISSION VALVE BODY Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Installation of transmission 3 way solenoid Assembly (S3)
1. Install the transmission 3 way solenoid Assembly (S3) with a bolt.
  Standard value: T=10N.m {102kgf.cm} {7ft.lbf}
  
  Fig 1: Installing Transmission 3 Way Solenoid Assembly (S3) With Bolt
  Courtesy of SUBARU OF AMERICA, INC.
Installation of transmission 3 way solenoid Assembly (S2)
1. Install the transmission 3 way solenoid Assembly (S2).
  Standard value: T=10N.m {102kgf.cm} {7ft.lbf}
  
  Fig 2: Installing Transmission 3 Way Solenoid Assembly (S2)
  Courtesy of SUBARU OF AMERICA, INC.
Installation of transmission 3 way solenoid Assembly (S1)
1. Install the transmission 3 way solenoid Assembly (S1).
  
  Fig 3: Installing Transmission 3 Way Solenoid Assembly (S1)
  Courtesy of SUBARU OF AMERICA, INC.
Installation of transmission 3 way solenoid Assembly (S4)
1. Install the transmission 3 way solenoid Assembly (S4) and harness clamp with a bolt.
  Standard value: T=10N.m {102kgf.cm} {7.4ft.lbf}
  
  CAUTION: Do not contact the S1 solenoid connector with the bolt when tightening the bolt.
  
  Fig 4: Installing Transmission 3 Way Solenoid Assembly (S4)
  Courtesy of SUBARU OF AMERICA, INC.
Installation of transmission 3 way solenoid Assembly (SR)
1. Install the transmission 3 way solenoid Assembly (SR) with a bolt.
  Standard value: T=10N.m {102kgf.cm} {7.4ft.lbf}
  
  Fig 5: Installing Transmission 3 Way Solenoid Assembly (SR)
  Courtesy of SUBARU OF AMERICA, INC.