TRANSMISSION CONTROL COMPUTER Assembly: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnection of battery ground terminal (refer to REMOVAL )
Removal of instrument side panel LH (refer to DISASSEMBLY )
Removal of instrument panel under cover Sub-Assembly No. 1 (refer to LIGHT CONTROL RHEOSTAT )
Removal of transmission control computer Assembly
1. Disconnect the 2 connectors from the transmission control computer Assembly.
2. Remove 2 nuts to remove the transmission control computer Assembly.
  
  Fig 1: Locating Transmission Control Computer Assembly Connectors And Nuts
  Courtesy of SUBARU OF AMERICA, INC.
3. Remove 2 nuts to remove the transmission control computer Assembly from the transmission control computer bracket.
  
  Fig 2: Locating Transmission Control Computer Bracket Nuts
  Courtesy of SUBARU OF AMERICA, INC.