TRANSMISSION CONTROL COMPUTER Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Installation of transmission control computer Assembly
1. Install the transmission control computer Assembly to the transmission control computer bracket with 2 nuts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
2. Install the transmission control computer Assembly with 2 nuts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
3. Connect the 2 connectors to the transmission control computer Assembly.
Installation of instrument panel under cover Sub-Assembly No. 1 (refer to INSTALLATION )
Installation of instrument side panel RH (refer to INSTALLATION )
Connection of the battery ground terminal
Initialization when removing/installing battery terminals
(Refer to WORKING PRECAUTIONS AND NOTES )