Unit inspection

WARNING: This page is about a different variant/trim than selected.

Check of neutral start switch Assembly

Measure the resistance between the terminals.

Resistance

Inspection terminals	Inspection conditions	Standard value
2(RB) - 6(PL) 4(B) - 5(L)	Select lever in P position	Less than 1 Ω
2(RB) - 1(RL)	Select lever in R position	Less than 1 Ω
2(RB) - 9(NL) 4(B) - 5(L)	Select lever in N position	Less than 1 Ω
2(RB) - 7(DL)	Select lever in D position When select lever is in M position and shifted to "+" or "-"	Less than 1 Ω
2(RB) - 6(PL) 4(B) - 5(L)	Select lever in any other than P position	10 kΩ or more
2(RB) - 1(RL)	Select lever in any other than R position	10 kΩ or more
2(RB) - 9(NL) 4(B) - 5(L)	Select lever in any other than N position	10 kΩ or more
2(RB) - 7(DL)	Select lever in any other than D position Except when select lever is in M position and shifted to "+" or "-"	10 kΩ or more

Fig 1: Neutral Start Switch Assembly Connector Terminal Identification

Courtesy of SUBARU OF AMERICA, INC.