Freeze Frame Data
WARNING: This page is about a different variant/trim than selected.
- Freeze data table
- Use SSM3 to select [Freeze Frame Data Display] on the [Transmission Control System] screen according to the screen display.NOTE:
- The transmission condition (TCM data) when a diagnostic code is detected and 2 seconds before a diagnostic code is detected can be checked at intervals of 0.5 seconds. (Refer to TROUBLESHOOTING PROCEDURES FOR ECM CONTROL SYSTEM )
- Check the consistency of the interviewed trouble phenomenon and the list of diagnostic codes.
- After repair, perform a confirmation test by referring to the driving condition checked above.
Item name [Coolant Temp.] [Shift SW Status History (P Range)] [Engine Speed] [Shift SW Status History (R Range)] [Vehicle Speed] [Shift SW Status History (N Range)] [Time Since Engine Start] [Shift SW Status History (D Range)] [Number of warm-ups] [Manual SW History] [Meter since DTC cleared] [Up SW History] [Time since DTC cleared] [Down SW History] [Control module voltage] [Snow Mode History] [Freeze frame data] [Snow SW History] [Engine Speed] [Sport SW History] [Coolant Temp.] [A/C Switch History] [Accel. Opening Angle] [TC Terminal] [Throttle Opening Angle] [Turbine Revolution Speed] [Stop Light Switch] [AT Speed] [Shift SW Status (P Range)] [ATF Temp.] [Shift SW Status (R Range)] [Shift Indicator Lamp UP Shift] [Shift SW Status (N Range)] [Shift Indicator Lamp Down Shift] [Shift SW Status (D Range)] [Sport Mode] [Manual SW] [Control the Shift Position] [Up SW] [Lock up status] [Down SW] [SLT Solenoid Status] [Snow Mode] [Activate the Lock Up (SLT)] [Snow SW] [# Codes(Include History)] [A/C Switch] [Trip Count] [Stop Light Switch History] [Count] - Use SSM3 to select [Freeze Frame Data Display] on the [Transmission Control System] screen according to the screen display.