Circuit description
WARNING: This page is about a different variant/trim than selected.
The transmission revolution sensor (NT) inputs the input shaft revolution speed to the transmission control computer ASSY as a signal.
The transmission control computer ASSY performs shift timing control based on signals from transmission revolution sensor (NT) and transmission revolution sensor (SP2).
DTC DETECTION CONDITION
| DTC No. SAE/TCCS |
DTC detecting condition
- Diagnosis condition
- Abnormal condition
- Abnormal period
- Other
|
Inspection parts |
| P0717 |
- Transmission 3 way solenoid ASSY (S1, S2, S3, S4, SR), transmission revolution sensor (SP2), shift position sensor, clutch control solenoid No. 1 (SL1, SL2), and line pressure control solenoid ASSY (SLT) are normal. When driving in D position, the revolution speed of the transmission revolution sensor (NT) calculated from the transmission revolution sensor (SP2) is 550 r/min or more. (2.5 seconds or more passed after shifting to D position. However, when the oil temperature sensor is faulty and the oil temperature is 20°C or lower, 10 seconds or more passed after shifting to D position).
- When the transmission revolution sensor (SP2) outputs 12 pulses, the transmission revolution sensor (NT) does not detect even 1 pulse.
- Detected 500 times consecutively
- 1 trips
|
- Transmission revolution sensor (NT)
- Wiring harness or connector
- Transmission control computer ASSY
|