Circuit description
WARNING: This page is about a different variant/trim than selected.
The transmission revolution sensor (NT) inputs the input shaft revolution speed to the transmission control computer ASSY as a signal.
The transmission control computer ASSY performs shift timing control based on signals from transmission revolution sensor (NT) and transmission revolution sensor (SP2).
DTC DETECTION CONDITION
| DTC No. SAE/TCCS |
DTC detecting condition
- Diagnosis condition
- Abnormal condition
- Abnormal period
- Other
|
Inspection parts |
| P0716 |
- Engine RPM remains 400 RPM or higher for 2 seconds or more. With the shift position sensor in D position, a ratio of the vehicle speed determined from the output vehicle speed sensor to VDC vehicle speed is less than 5 %, and a ratio of the vehicle speed determined from the engine RPM and VDC wheel speed is less than 5 %. (2.5 seconds has elapsed after shift position has moved to D position. However, when the oil temperature sensor is faulty and the oil temperature is 20°C or lower, 10 seconds or more passed after shifting to D position).
- Ratio of vehicle speed determined from transmission revolution sensor (NT) to VDC wheel speed is more than 15 %.
- 10 seconds
- 1 trips
|
- Transmission revolution sensor (NT)
- Wiring harness or connector
- Transmission control computer ASSY
|