Inspection steps

WARNING: This page is about a different variant/trim than selected.

Check of shift lock solenoid unit
1. Check the shift lock solenoid unit. (Refer to UNIT INSPECTION )
  NG: Replacement of shift lock solenoid (refer to REMOVAL )
  
  OK: Go to next step

Check wiring harness and connector (main body ECM (network gateway computer) - shift lock solenoid)

NOTE: Refer to INSPECTION PROCEDURES FOR ELECTRICAL CIRCUITS AND HOW TO PERFORM for checking procedure and precautions

Measure the resistance between the terminals.

RESISTANCE SPECIFICATION (DISCONNECTION CHECK)

Inspection terminals	Inspection conditions	Standard value
D5-20 - D28-4	Always	Less than 1 Ω

RESISTANCE SPECIFICATION (SHORT CHECK)

Inspection terminals	Inspection conditions	Standard value
D5-20 and D28-4 - chassis ground	Always	10 k Ωor more

Connect the connector D5 of the main body ECM (network gateway computer).
Connect the connector D28 of the shift lock solenoid.
NG: Repair or replacement of wiring harness or connector

OK: Go to next step

Check wiring harness and connector (shift lock solenoid-chassis ground)

NOTE: Refer to INSPECTION PROCEDURES FOR ELECTRICAL CIRCUITS AND HOW TO PERFORM for checking procedure and precautions

Measure the resistance between the terminals.

Resistance

Inspection terminals	Inspection conditions	Standard value
D28-5 - chassis ground	Always	Less than 1 Ω

Connect the connector D28 of the shift lock solenoid.
NG: Repair or replacement of wiring harness or connector

OK: Replacement of main body ECM (network gateway computer) (refer to REMOVAL )