Checking/Clearing Diagnostic Codes
WARNING: This page is about a different variant/trim than selected.
- DTC check (read by SSM3)
- Use SSM3 to display the [Transmission Control System] screen according to the screen display and select [Diagnostic Code(s) Display].
- Check the diagnostic codes.
- Freeze frame data
- Use SSM3 to select [Freeze Frame Data Display] on the [Transmission Control System] screen according to the screen display.NOTE:
- The transmission condition (TCM data) when a diagnostic code is detected and 2 seconds before a diagnostic code is detected can be checked at intervals of 0.5 seconds. (Refer to TROUBLESHOOTING PROCEDURES FOR ECM CONTROL SYSTEM )
- Check the consistency of the interviewed trouble phenomenon and the list of diagnostic codes.
- After repair, perform a confirmation test by referring to the driving condition checked above.
- Use SSM3 to select [Freeze Frame Data Display] on the [Transmission Control System] screen according to the screen display.
- Diagnostic codes memory clear (cleared by SSM3)
- Use SSM3 to display the [Transmission Control System] screen according to the screen display and select [Clear Memory].
- Select [Yes] displayed on the screen to clear the data.CAUTION: Diagnostic codes and freeze frame data are cleared at the same time.