Intake Duct: Installation

Install in the reverse order of removal.

NOTE: Use a new clamp. To connect the PCV hose assembly, fit the cut outs of the ST with the protrusions on the clamp as shown in the figure, squeeze the ST's handles together and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Connecting PCV Hose Assembly Using Clamp Pliers (18353AA000)

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating PCV Hose Assembly Clamp

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

17 N.m (1.7 kgf-m, 12.5 ft-lb)