LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX STI Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Center Console >> Removal

Center Console: Removal

  1. Disconnect the ground cable from battery. <Ref. to BATTERY , NOTE, Note.>
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the panel center assembly.
    CAUTION:
    • Do not put your finger on the fin of the air vent grille. Doing so may damage the fin.
    • Pull the panel center assembly slowly. Pulling with excessive force may damage the connector.
    1. Insert a plastic remover to the three areas shown by the arrows, and slightly lift up the panel center assembly.
    2. With the panel center assembly lifted up slightly, release the claw by using a clip remover wrapped with protective tape.
    3. Release the rest of the claws, and pull out the panel center assembly.
      Fig 1: Pulling Out Panel Center Assembly
      G10271212Courtesy of SUBARU OF AMERICA, INC.
    4. Disconnect the connectors, and remove the panel center assembly.
      1. Disconnect the connector of the switch - hazard switch.
      2. Disconnect the connector of heater control assembly.
      3. Push out the switch - MFD from the back side of panel center assembly, and disconnect the connector.
scientia non olet · About LEMON Manuals