Intake Duct No. 3

Align the triangle mark (A) on the intake duct No. 3 to the rib (B) on the throttle body, and install the intake duct No. 3 to the throttle body.
NOTE:
- Use a new insulator.
- Apply a thin coat of SUBARU PS fluid (K0515YA000) or liquid paraffin to the inner periphery of the insulator.
- When inserting the intake duct No. 3 to the throttle body, be careful that the insulator is not turned over.
Tightening torque:

3 N.m (0.3 kgf-m, 2.2 ft-lb)

Fig 1: Identifying Triangle Mark On Intake Duct No. 3 To Rib
Courtesy of SUBARU OF AMERICA, INC.
Install the clip which secures the brake booster vacuum hose to the intake manifold.
NOTE: Install the clip to the position of alignment mark of intake manifold.

Fig 2: Locating Brake Booster Vacuum Hose Clips
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. <Ref. to INSTALLATION , Intercooler.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Note.>
Install the collector cover. <Ref. to INSTALLATION , Collector Cover.>