LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) >> Blower Motor Unit Assembly >> Removal

Blower Motor Unit Assembly: Removal

  1. Disconnect the ground cable from battery. <Ref. to BATTERY , NOTE, Note.>
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the glove box. <Ref. to REMOVAL , Glove Box.>
  3. Remove the engine control module (ECM). (STI model) <Ref. to REMOVAL , Engine Control Module (ECM).>
  4. Remove the blower motor unit assembly.
    1. Release the claws, and then remove the grille assembly - ventilation RH.
    2. Disconnect the blower motor relay and each connector.
      Fig 1: Locating Grille Assembly Connector - Ventilation RH
      G10270282Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolts and nuts to remove blower motor unit assembly.
      NOTE: Remove the RH upper nut from the mounting portion of the grille assembly - ventilation RH.
      Fig 2: Locating Grille Assembly Nut - Ventilation RH
      G08316131Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals