LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (M/T Clutch System) >> Clutch Switch >> Inspection >> Clutch Switch

Clutch Switch

WARNING: This page is about a different variant/trim than selected.
  1. Check the clutch switch for continuity.
    1. Disconnect the connector of clutch switch.
    2. Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not within the specification, check the clutch stroke and installation condition, and check the clutch switch again.
      Condition Terminal No. Specified resistance
      When clutch pedal is depressed No. 1 - No. 2 1 MΩ or more
      When the clutch pedal is not depressed No. 1 - No. 2 Less than 1 Ω
      Fig 1: Measuring Resistance Between Clutch Switch Terminal 1 And 2
      G05003713Courtesy of SUBARU OF AMERICA, INC.
  2. When the clutch switch does not operate normally even if the clutch stroke and installation condition are normal, check the clutch switch for continuity.
    1. Remove the clutch switches. <Ref. to REMOVAL , Clutch Switch.>
    2. Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
      Condition Terminal No. Specified resistance
      ON No. 1 - No. 2 Less than 1 Ω
      OFF No. 1 - No. 2 1 MΩ or more
      Fig 2: Measuring Resistance Between Switch Terminal 1 And 2
      G05003713Courtesy of SUBARU OF AMERICA, INC.
    3. Check that the switch is turned on and off in Dimension L.

      Dimension L: 

      5 - 6.5 mm (0.2 - 0.26 in) 

      Fig 3: Identifying Switch Dimension L
      G10269385Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals