LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (M/T Clutch System) >> Clutch Pipe and Hose >> Removal

Clutch Pipe and Hose: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery. <Ref. to BATTERY , NOTE, Note.>
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the intercooler. <Ref. to REMOVAL , Intercooler.> <Ref. to REMOVAL , Intercooler.>
  3. Drain the clutch fluid. <Ref. to CLUTCH FLUID .>
  4. Remove the clutch pipe from the master cylinder.
  5. Disconnect the hose from operating cylinder.
  6. Remove the clutch bracket from the bulkhead.
  7. Remove the clutch pipe from the clutch hose.
  8. Remove the clutch pipe and clip from the clutch bracket.
scientia non olet · About LEMON Manuals