Clutch Pipe and Hose: Installation

WARNING: This page is about a different variant/trim than selected.

Install the clutch hose and clip to the clutch bracket.
NOTE: Be sure to install the clutch hose with the mark side facing towards vehicle top.
Connect the clutch pipe to the clutch hose.
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)

Fig 1: Identifying Clutch Bracket, Clutch Pipe, Clip
Courtesy of SUBARU OF AMERICA, INC.
Attach the clutch bracket to the bulkhead.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 2: Identifying Clutch Pipe, Clip, Clutch Hose, Clutch Bracket
Courtesy of SUBARU OF AMERICA, INC.
Connect the clutch hose to the operating cylinder.
NOTE:
- Use a new gasket.
- Be sure to install the clutch hose with the mark side facing upward.
- Be careful not to twist the clutch hose during installation.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Connect the clutch pipes to the master cylinder.
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)
Bleed air from the clutch fluid. <Ref. to CLUTCH FLUID AIR BLEEDING .>
Install the intercooler. <Ref. to REMOVAL , Intercooler.> <Ref. to REMOVAL , Intercooler.>