Malfunction Indicator Light Does Not Blink: Wiring Diagram
WARNING: This page is about a different variant/trim than selected.
- Engine Electrical System ENGINE TYPE EJ (WITHOUT PUSH BUTTON START) <Ref. to 2.5L TURBO (WITHOUT PUSH BUTTON START), WIRING DIAGRAM, Engine Electrical System.>
- Engine Electrical System ENGINE TYPE EJ (WITH PUSH BUTTON START) <Ref. to 2.5L TURBO (WITH PUSH BUTTON START), WIRING DIAGRAM, Engine Electrical System.>
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK STATUS OF MALFUNCTION INDICATOR LIGHT.
|
Does the malfunction indicator light illuminate? | Go to step 2 . | Repair the malfunction indicator light circuit. <Ref. to MALFUNCTION INDICATOR LIGHT DOES NOT COME ON , Malfunction Indicator Light.> |
2 CHECK HARNESS BETWEEN ECM AND DELIVERY MODE FUSE.
|
Is the resistance less than 1 Ω? | Go to step 3. | Repair the harness and connector.
NOTE:
In this case, repair the following item:
|
| 3 CHECK FOR POOR CONTACT. Check for poor contact of ECM connector. |
Is there poor contact of ECM connector? | Repair the poor contact of ECM connector. | Replace the ECM. <Ref. to ENGINE CONTROL MODULE (ECM) .> |