When The Si-Drive Mode Is Changed, "S", "I" Or "S#" Flashes In Combination Meter Si-Drive Mode Display In Approx. 5 Seconds
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. | Is DTC displayed? | Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)" concerning the respective units. | Go to step 2. |
| 2 CHECK COMBINATION METER AND CLOCK DISPLAY. Check for abnormal display other than "S", "I" or "S#" flashing. Examples: Malfunction indicator light illuminates. |
Is there an abnormal display other than "S", "I" or "S#" flashing? | For the diagnostic procedure, refer to LAN article. <Ref. to BASIC DIAGNOSTIC PROCEDURE .> | Go to step 3. |
| 3 CHECK ECM AND COMBINATION METER. | Is the part number of ECM and combination meter correct? | Replace the meter case assembly. <Ref. to COMBINATION METER .> | Replace ECM or meter case assembly with the one with the correct part number. <Ref. to ENGINE CONTROL MODULE (ECM) .> <Ref. to COMBINATION METER .> |