DTC P1410 Secondary Air Injection System Switching Valve Stuck Open: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Immediately at fault recognition
GENERAL DESCRIPTION <Ref. to DTC P1410 SECONDARY AIR INJECTION SYSTEM SWITCHING VALVE STUCK OPEN , Diagnostic Trouble Code (DTC) Detecting Criteria.>

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK SECONDARY AIR COMBINATION VALVE. Remove the secondary air combination valve. <Ref. to SECONDARY AIR COMBINATION VALVE .> Blow in air from the secondary air combination valve air inlet, and check whether there are leaks at the pipe connections.	Are there air leaks from the pipe connections?	Replace the secondary air combination valve on the side with the air leak. <Ref. to SECONDARY AIR COMBINATION VALVE .>	Perform the diagnostic procedure of DTC P2440. <Ref. to DTC P2440 SECONDARY AIR INJECTION SYSTEM SWITCHING VALVE STUCK OPEN (BANK 1) , Diagnostic Procedure with Diagnostic Trouble Code (DTC).>