DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Trouble Symptom
WARNING: This page is about a different variant/trim than selected.
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to
OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to
PROCEDURE , Inspection Mode.>.
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2 . | Tighten the crankshaft position sensor installation bolt securely. <Ref. to CRANKSHAFT POSITION SENSOR .> |
| 2 CHECK CRANK SPROCKET. Remove the timing belt cover. |
Are crank sprocket teeth cracked or damaged? | Replace the crank sprocket. <Ref. to CRANK SPROCKET .> | Go to step 3. |
| 3 CHECK INSTALLATION CONDITION OF TIMING BELT. Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 499987500 CRANKSHAFT SOCKET |
Is the timing belt dislocated from its proper position? | Repair the installation condition of timing belt. <Ref. to TIMING BELT .> | Replace the crankshaft position sensor. <Ref. to CRANKSHAFT POSITION SENSOR .> |