LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls (Diagnostics) (H4DOTC) (STI)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0116 Engine Coolant Temperature Sensor 1 Circuit Range/Performance >> Trouble Symptom

DTC P0116 Engine Coolant Temperature Sensor 1 Circuit Range/Performance: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.
CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK FOR ANY OTHER DTC ON DISPLAY.  Is any other DTC displayed? Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .> Go to step 2. 
2 CHECK ENGINE COOLANT TEMPERATURE SENSOR. 
  1. Disconnect the connectors from the engine coolant temperature sensor.
  2. Measure the resistance between engine coolant temperature sensor terminals when the engine coolant is cold and after warmed up.

    Terminals 

    No. 1 - No. 2: 

Is the resistance of engine coolant temperature sensor different between when engine coolant is cold and after warmed up? Repair the poor contact of ECM connector. Replace the engine coolant temperature sensor. <Ref. to ENGINE COOLANT TEMPERATURE SENSOR .>