Chamber Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the chamber duct to the chamber assembly, and tighten the clamp which holds the chamber assembly and chamber duct.
NOTE: Align the positioning protrusion section (a) of the chamber assembly to the concave section (b) of the chamber duct side, and securely insert until the end face of chamber duct contacts the chamber assembly.

Fig 1: Identifying Chamber Assembly Protrusion And Concave Sections
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

2.5 N.m (0.3 kgf-m, 1.8 ft-lb)

Fig 2: Locating Chamber Duct Clamp
Courtesy of SUBARU OF AMERICA, INC.