PCV Hose Assembly: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not remove unless the hose and the diagnostics connector are broken.

Disconnect the connector (A) from the PCV hose assembly A.
Remove the PCV hose assembly A from the clip (B), and remove the PCV hose assembly A from the PCV pipe.
NOTE: Pinch the clamp of the PCV hose assembly A by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Identifying Clamp Pliers (ST 18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating Clamp Of PCV Hose Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the connector from the PCV hose assembly B.

Fig 3: Locating Connector From PCV Hose Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the PCV hose assembly B from the intake duct.
NOTE: Pinch the clamp of the PCV hose assembly B by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 4: Identifying Clamp Pliers (ST18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 5: Locating Clamp Of PCV Hose Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the intake manifold. <Ref. to REMOVAL , Intake Manifold.>
Remove the turbocharger. <Ref. to REMOVAL , Turbocharger.>
Remove the PCV hose assembly C from the cylinder block RH.
NOTE: Pinch the clamp of the PCV hose assembly C by fitting the cut out in the ST with the protrusion on the clamp as shown in the figure, and unlock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 6: Identifying Clamp Pliers (ST18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 7: Locating Clamp Of PCV Hose Assembly
Courtesy of SUBARU OF AMERICA, INC.